TruSeal separators allow the fabrication of a hermetic glass unit double curve. The spacers are EDGETHERM DVH curve or Microseal DS. Not recommended to use the system to have a flexible DURA reduced side.
separator also use requires the application tool PEAK TOOL, especially for such applications.
Because it is difficult to obtain the same curve in both glasses, we recommend the use of secondary seal.
1 - Apply the spacer on the edge of 1 of the curved glass. Peak use tool Tool 
2 - Check the correct application of the separator at the 4 edges of curved glass. 
3 - Assemble second curved glass. Take care that both are framed. 
4 - Apply the clamps on the edge of the unit. 
5 - Place the clips every 150 mm to ensure a charge pair in the perimeter. 
6 - Place the unit curve in a position that allows the heating of the 4 edges. With the heat gun to heat the unit until its edge reaches 45 ° C. Check the temperature with an infrared thermometer. Then, with one foot underground control the total thickness of the unit. Reheat
the fourth corner to proceed to seal the unit, use the Teflon block.
Allow unit to cool until it reaches 24 ° C, then you can apply the secondary seal. If in doubt, ask your agent TruSeal.
0 comments:
Post a Comment